HOW
TO USE THE BATH 2000
(See Special Notes on hot tub/spa use)
1. Turn on the tub faucet and immerse the BATH 2000 in the water to thoroughly
wet the fabric bag. This speeds up the water flow through the media pouch.
Adjust your water temperature to 105 to 110 degrees F or even warmer.
2. To accelerate dechlorination you can hang the BATH 2000 on the tub spout
by hooking the BATH 2000 cord on the spout. This allows for immediate contact
of all the incoming water with the F-73 filament.
3. After filling the tub, swirl the BATH 2000 through the tub for about 2 to
3 minutes. In the time it takes to complete steps #2 and #3, chlorine and chloromines
should have been reduced by 90% or more.
4. To achieve 100% chlorine removal take the BATH 2000 out of the tub to avoid
any chance of stepping on it and then return the BATH 2000 to the water after
you are in the tub. You can swirl the BATH 2000 through the water for another
minute or two. You can return the BATH 2000 to the tub if you add more water.
5. After your bath, hang the BATH 2000 on the faucet or a hook to dry.
6. Replace the filament pouch with a fresh pouch after a yearıs usage
or about 300 baths. Service life could be longer depending on water
conditions
FOR
INFANT BATHING
The
BATH 2000 is very effective for bathing babies
in small tubs or basins (approximately
3 to 5 gallons). A babyıs
delicate skin is greatly benefited by removing
toxic chlorine. Follow these
steps:
1. Fill your tub or basin with the bath water at your required temperature.
2. Place the BATH 2000 into the water and swirl the ball through the water
for 2 to 3 minutes. If you need more hot water just swirl the BATH 2000 for
a few more seconds.
3. Important. Remove the BATH 2000 from the tub or basin before placing the
baby in the water. While completely safe, the BATH 2000 is not a tub toy.
4. Hang the BATH 2000 up to dry after using.
IMPORTANT
NOTES ON HOT TUB AND SPA USE
The
BATH 2000 may be used to remove chlorine from
hot tubs and spas, but it may
take longer or require two plastic
balls because of the greater volume of water
than a
bathtub. Very Important. Once you have removed
chlorine from a hot tub or spa,
you must follow the hot tub
or spa manufacturerıs instructions on sanitizing
the tubs/spas between uses. If you fail to
re-disinfect
the tub/spa you could encourage unwanted bacteria
or fungus growth.
HOW
IS IT USED?
The
BATH 2000 dechlorinates the water by placing
it into the tub and pulling
it through the water with the attached
12" cord for a few minutes. To accelerate
dechlorination you may hang the BATH 2000
on the tub spout
and let the incoming water agitate the BATH
2000.
The
12ı cord is also used to hang the ball on a hook or
fixture to dry between uses. The BATH 2000 has a flat
bottom so it can be placed on a surface without rolling.
The unit should be kept clean as possible to maintain
a long filter life. The BATH 2000 is not a toy and
while it is completely safe and non-toxic, it should
not be used as a child or infantıs toy.
Please remove it from the bathtub before
using the
tub to avoid the
possibility of stepping on the plastic
ball. If you add more water to the tub
while bathing
you may swirl
the BATH 2000 through the water for another
minute or so to remove any new chlorine.
WHAT
IS THE MEDIA USED TO DECHLORINATE AND TREAT THE WATER?
1.
1.5 oz. KDF Formula 73 Copper-Zinc filament.
2. 1 oz. Virgin American Crystalline Quartz.
WHAT
IS SPECIAL ABOUT THE KDF FORMULA 73 FILAMENT?
KDF
Formula 73 (F-73) is a specially processed alloy of
70% copper and 30% zinc. The filament is processed
by special machinery which produces a fine, hair-like
strand of brass only 60 to 80 micons in thickness,
about the same as a human hair.
Each
BATH 2000 contains 1 _ oz. of F-73 strands
which if laid end to end would extend over
4000 feet. This provides
the BATH 2000 with a great surface area
which in turn accelerates the electro-chemical action
of the F-73.
The Rainshowır BATH 2000 is absolutely
unique. There is nothing with which to
compare it.
HOW
DOES KDF FORMULA WORK IN REMOVING CHLORINE?
As
chlorinated water flows through the filament the dissimilar
metals in KDF, (copper and zinc), create a galvanic
or electrolytic reaction which causes the two chlorine
ions to combine with a zinc ion to form a harmless
zinc chloride (ZNCL2). KDF does not hold the chlorine.
It changes the chlorine from an element into a harmless
compound.
PLEASE
EXPLAIN HOW KDF F-73 WORKS IN REMOVING CHLORAMINES
FROM THE BATH WATER.
Chlorine
can combine with ammonia and nitrogen compounds to
create chloramines. These chloramines smell bad and
are body irritants. Chloramine smell is most often
associated with the smell of indoor pools. But chloramines
are also created by water treatment districts by adding
ammonia to the water in order to disinfect water supplies
and to comply with the Federal Safe Drinking Water
Act.
Treatment
plant chloramines (CL2:NH3) also reduce
chlorineıs
ability to combine with organic matter which, when
it occurs, can create a series of carcinogens called
THMıs or Trihalomethanes.
Chloramines
are relatively stable and cannot be removed
by a shower filter without the use of chemicals
because the flow
rate is too fast. This is not regarded
as a dermal problem because exposure time to chloramines
in a shower
is very short. But, this is not the case
in
a tub bath where the user can deep soak for 20
minutes or more.
Rainshowır Mfg. Co.ıs research and work
experience with KDF in filament covers
more than 10
years. Based on that work we knew if the
motive or
driving power
of the filament could be increased we might
break or destabilize the chlorine-ammonia
bond. Our custom-made
KDF Formula 73 does just that. KDF allows
us to break the connection between chlorine
and
ammonia, liberating
the free chlorine and allowing it to combine
with zinc in the F-73. This instantly converts
the free chlorine
into a harmless zinc chlorine salt (ZNCL2).
This
very simple and safe use of scienceıs age
old knowledge of dissimilar metals technology
enables
us to remove
up to 100% of total chlorine at elevated
bathing temperatures (105-110 degrees F)
in about 4
to 5 minutes from the
time the faucet is turned on.
WHAT
IS THE ADVANTAGE OF CRYSTALLINE QUARTZ?
Our
specially washed and sun dried quartz
crystals help to "energize" the water by reducing the waterıs surface
tension. This allows for an increase in sudsing and
lathering of soaps and shampoos. The water has a "lighter" feel,
similar to the feeling of softened water.
Please
check our web site www.rainshowrmfg.com for our in
depth technical report on the use of electromagnetic
crystal in our dechlorinating bath and shower filters.
ARE
ANY MATERIALS USED IN THE BATH 2000 EITHER HARMFUL
OR TOXIC?
No.
KDF media is widely used in drinking water and water
treatment systems. It also conforms to the U.S. Drinking
Water Act (PL99-399 of 6/19/86).
Our
crystalline quartz is pure American mined silicon dioxide
(S1O2) specially washed and sun cured. It is chemically
inert.
The
BATH 2000 is completely American made including all
components and raw materials.